RB25DET Intake Manifold Fitting

Attention RB25 Owners!

As RB25 engines age, the need for replacement parts due to deterioration and corrosion is increasing.
In response to high customer demand—especially as genuine parts become discontinued or prohibitively expensive—HPI has developed this reliable aftermarket replacement. Designed to help you maintain your vehicle for the long term.
 
RB25DET Intake Manifold Fitting
Specifications
Equivalent Genuine Part Number: 14001-02U01 (35mm hose barb only)
Note: Genuine parts are normally only supplied as a complete intake manifold assembly.
 
Compatibility: Specifically for RB25 engines
Material: S45C (Zinc Plated)
 
Precautions for Installation & Use
・Always verify the dimensions of both the mounting points and the product before installation.
・If excessive rust or corrosion is present on the mounting area, properly clean and repair the surface before proceeding.
・If any defects are found, do not attempt to modify the part; stop use immediately and contact your dealer.
・Applying liquid gasket to the mounting surface during installation is strongly recommended.
・When press-fitting, always verify the dimensions of both the engine side and the product, and use a proper press tool to insert the part perfectly straight.
Forcing the part in at an angle or with incorrect dimensions will cause water leaks.
・In some cases, shrink-fitting (such as heating the mounting area or the body) may be required.
・Do not strike the product directly with a hammer or apply heavy impacts, as this will cause deformation or peeling of the plating.
 　・Note: If tapping is absolutely necessary for adjustment, ensure the area is well-protected.
Use a plastic hammer or a backing plate and proceed cautiously, checking each step.

Part Number : HP-14001-02U01